In this article I will discuss how to apply the settings Bullet 2HP as BTS transmitter that can be received directly by the user's laptop (Access Point) and at the same time using one of the first experience Ubiquiti products.
Following the steps of his setting:
1.Setelah all the instruments have been correct installation, connect the UTP cable to the computer via POE
mate with a straight connection type and then note the IP address bullet which by default is 192.168.1.20,
then set the IP for example 192.168.1.21 pal Lan computer then fill in the Default Gateway the same as IP
Bulletnya.
2.Selanjutnya please my friend open the browser and then fill in the address bar 192.168.1.20, so if the
correct setting will appear AirOS bulletnya early, so my friend can see on the Main tab there is information
about setting the default bullet.
3.For start setting the bullet as a transmitter, and then select Link Setup tab and set the Wireless Mode on
Point or WDS Accsess it, if my friend wanted the bullet as a receiver in this case acts as a client then select
Station. Transmitter is loaded SSID name pal. Because the bullet I want to make as a transmitter that can
be received directly by the user's laptop then on my chosen mode of IEEE 802.11 B / G Mixed, then to
Channel Spectrum Width at 20MHz and should select its consumer and small channel selected Output
Power 20 dbm.
4.And than set the default setting bullet Network Mode Network in Bridge mode, static IP address with IP
address bullet loaded as follows:
IP Address: 192.168.1.20 Netmask: 255.255.255.0 IP Gateway: 192.168.1.1 Primary DNS IP: 202.134.0.155 Secondary DNS IP: 202.134.0.62
IP set wifi laptop 5.Kemudian pal same IP bulletnya because bullets are in bridge mode. Until this stage settings as Accsess Point bullet is finished and then do the ping, if the settings are correct reply.
Following the steps of his setting:
1.Setelah all the instruments have been correct installation, connect the UTP cable to the computer via POE
mate with a straight connection type and then note the IP address bullet which by default is 192.168.1.20,
then set the IP for example 192.168.1.21 pal Lan computer then fill in the Default Gateway the same as IP
Bulletnya.
2.Selanjutnya please my friend open the browser and then fill in the address bar 192.168.1.20, so if the
correct setting will appear AirOS bulletnya early, so my friend can see on the Main tab there is information
about setting the default bullet.
3.For start setting the bullet as a transmitter, and then select Link Setup tab and set the Wireless Mode on
Point or WDS Accsess it, if my friend wanted the bullet as a receiver in this case acts as a client then select
Station. Transmitter is loaded SSID name pal. Because the bullet I want to make as a transmitter that can
be received directly by the user's laptop then on my chosen mode of IEEE 802.11 B / G Mixed, then to
Channel Spectrum Width at 20MHz and should select its consumer and small channel selected Output
Power 20 dbm.
4.And than set the default setting bullet Network Mode Network in Bridge mode, static IP address with IP
address bullet loaded as follows:
IP Address: 192.168.1.20 Netmask: 255.255.255.0 IP Gateway: 192.168.1.1 Primary DNS IP: 202.134.0.155 Secondary DNS IP: 202.134.0.62
IP set wifi laptop 5.Kemudian pal same IP bulletnya because bullets are in bridge mode. Until this stage settings as Accsess Point bullet is finished and then do the ping, if the settings are correct reply.