Already famous saebagai Mikrotik routers, commonly used in office or cafe. Likewise, the wireless mikrotik, in addition to the bias used for the router, the bias is also used only for access points only. Why is that, because the DHCP server and Hotspot already discover the previous server.
Topology below shows how the wireless Router Board (RB411) functioned as akases point only. In setting Akases Point (AP) there are two ways, first functioned as a router, meaning RB This is a Gateway Server. Where there is a DHCP server on this RB411.
Setting the second is as a Bridge (Bridging), which is a technique combining or bundling of the two interface without any deflection or processing of an IP address from one interface to another interface. By understanding the other interfaces in the bridge seemed to be fused into one, like a switch function only.
On this occasion that I have to say is how this RB411 functioned as an access point. The concept is to create a bridge between ether1 and wlan1 is in the interface. With the help of Winbox, click on the interface it will show ether1 and wlan1.
The next step is to create a bridge, at the interface click the + sign and select the bridge, it will show bridge1, then ok. New interfaces can be seen as shown below
Topology below shows how the wireless Router Board (RB411) functioned as akases point only. In setting Akases Point (AP) there are two ways, first functioned as a router, meaning RB This is a Gateway Server. Where there is a DHCP server on this RB411.
Setting the second is as a Bridge (Bridging), which is a technique combining or bundling of the two interface without any deflection or processing of an IP address from one interface to another interface. By understanding the other interfaces in the bridge seemed to be fused into one, like a switch function only.
On this occasion that I have to say is how this RB411 functioned as an access point. The concept is to create a bridge between ether1 and wlan1 is in the interface. With the help of Winbox, click on the interface it will show ether1 and wlan1.
The next step is to create a bridge, at the interface click the + sign and select the bridge, it will show bridge1, then ok. New interfaces can be seen as shown below